instal the last version for iphoneBitvise SSH Client 9.31

If all is well, after conducting these steps you are now accessing the SFTP server with your FTP client, using Bitvise SSH Client to translate from FTP to SFTP and vice versa. The FTP client can be configured with any username and password - these will be ignored because authentication has already been performed on the level of the SSH session. The SSH session needs to be established with the FTP Bridge component active when you do this. Use the FTP client to connect to localhost using the FTP protocol.

You should get a series of informational messages, and one of the last ones should say 'Enabled FTP-to-SFTP bridge on. Click the Help link on the Services tab for help with any of the more specific FTP Bridge settings.

The default values for the other FTP Bridge settings will usually work correctly.

On the Services tab of the SSH Client, make sure that the Enabled check box is checked in the FTP-to-SFTP Bridge section.

Store encrypted password in profile: You may optionally wish to enable this setting so that you will not be asked to reenter the password each time when logging in after Bitvise SSH Client has been restarted.

$instal the last version for iphoneBitvise SSH Client 9.31$

Password: The password with which to log into the SFTP server, belonging to the account name specified by Username.Username: The username with which to log into the SFTP server.This will usually be the default SSH port number ( 22). Port: The port number that the SSH/SFTP server is listening on.Host: The IP address or DNS name of the SFTP server that you are accessing.Click also the Help link on the Login tab for help with any of these settings. Configure the following settings on the Login tab of the SSH Client.Install Bitvise SSH Client on the client - the machine on which the FTP client program resides and from which you wish to access the SFTP server.The following instructions assume that the SFTP server you plan to be accessing is already set up, and that you have the username and password information necessary to log in with an SSH/SFTP client. Step-by-Step Instructions to Bitvise SSH Client's FTP Bridge In this case, protocol translation is required, and this can be done using Bitvise SSH Client as the intermediary program. However, there are times when one wishes to access an SFTP server with a program which does not support this protocol, but supports the legacy FTP protocol. Connecting to an SFTP Server with an FTP Clientīitvise SSH Client comes with a graphical SFTP file transfer client, as well as a scriptable command-line SFTP client.

Instal the last version for iphoneBitvise SSH Client 9.31